With the continuous improvement of life taste, people's attention began to shift to the appreciation of decorative details. In the current architectural decoration, because iron can be rigid and soft, with good performance, the description of details has unparalleled advantages of other materials, and also with its thick, strong, wear-resistant and unique charm, so that more and more users favor. Wrought iron gates often appear in people's lives, what is its construction scheme?

1, construction preparation:

The manufactured wrought iron gate should have a factory certificate and test report when entering the gate, and its specifications, models and dimensions should meet the design requirements. Put the window number in a safe place, pad the wood, and cover it. So as not to make mistakes, otherwise it is not good to cooperate with customers in the later stage.

Play the position line of the wrought iron gate, and determine the installation elevation according to the 50cm horizontal line.

The unpacking, inspection and transportation of wrought iron gates are even more important because customers do not want the wrought iron gates to be damaged during transportation. According to the requirements of the drawing to check the model and check the quality of the iron work, such as the lack of Angle and warping uneven deviation, serious damage scratches, the appearance of large color difference, should be carefully negotiated, after trimming, identification, before installation, but also check the iron work door is glued to the protective film, if there is a defect should be repaired after the construction and installation. Prepare the scaffolding and safety precautions for installation. Because safe production is the principle we have been pursuing.

2, construction points:

Wrought iron gate opening treatment:

The installation method of iron art is to reserve the hole and plug the back. The horizontal position of the iron opening should be based on the 50cm line of the wall, go up and back, measure the height of the skin under the window, and find the straight line. In order to ensure the upper and lower lines of each layer window, the theodolite is used to hit both sides of the wall in a straight line. The gap between the plastic steel frame and the wall is left 10-15mm on each side.

Wrought iron gate and wall connection:

Wrought iron gate The door frame is connected to the wall with fixed iron pieces. Use self-tapping screws to install the iron parts in the slot outside the window frame, and then send the wrought iron door frame into the hole positioning, the positioning point through the reserved hole of the iron parts, drill a hole in the opposite position of the wall and insert the expansion tube, tighten the expansion screw to fix the iron parts with the wall.

In fact, it can be simply put down to the following three points:

1. Application for material inspection

2. Quality inspection table

3. Concealed works